Twiflex多福GMR系列盘式制动卡钳| Twiflex 

Twiflex多福GMR和GMR40系列盘式制动卡钳分别适用于25.4毫米和40毫米厚的盘式制动卡钳。阀瓣直径为610毫米。 

Twiflex多福通常每个磁盘使用一个或两个卡尺，但数量可以根据磁盘大小而增加。Twiflex多福制动器可以以任何角度放置在阀瓣周围，水平安装(即在3点钟或9点钟位置)。如果卡尺安装角度大于10°从水平，或在垂直轴应用，它应该安装一个倾斜安装组件。一系列的制动盘可从Twiflex(参阅盘和毂组件)。 

对于气动操作，使用干燥、过滤和非润滑的压缩空气。气动制动器需要一个控制阀，可以手动操作，也可以通过气动或电信号操作。 

在图表上显示的额定值是基于完全铺设和条件刹车片与公称摩擦系数μ = 0.4。Twiflex盘式制动器必须使用Twiflex石棉无刹车片。 

Twiflex多福盘式制动器有效圆盘半径=实际半径(m) - 0.06m。

GMR Series Disc Brake Caliper | Twiflex

The Twiflex GMR and GMR40 series of disc brake calipers is suitable for use with discs of 25.4mm, and 40mm thick respectively. Minimum disc diameter is 610mm.

Normally one or two calipers are used per disc, but the number may be increased depending on disc size. The brakes may be positioned at any angle around the periphery of the disc, but should ideally be mounted horizontally (i.e. at the 3 o’clock or 9 o’clock position). If the caliper mounting angle is greater than 10° from the horizontal, or on vertical shaft applications, it should be fitted with an inclined mounting kit. A range of brake discs is available from Twiflex (see Disc and Hub Assemblies).

For pneumatic operation use dry, filtered and non-lubricated compressed air. Pneumatic brakes require a control valve, operated either manually or by pneumatic or electrical signal.

The ratings shown on the graphs are based on fully bedded in and conditioned brake pads with a nominal friction coefficient μ = 0.4. Twiflex disc brakes must be used with Twiflex asbestos free brake pads.

Effective disc radius = actual radius (m) – 0.06m.